CoFeSiB非晶丝弱磁场测量仪的研制

设计了以Co基非晶丝为敏感元件的传感器探头,多谐振荡励磁电路,信号处理电路,单片机显示电路,且对该磁场测量仪进行了标定。     

Ignition of hydrogen–oxygen and stoichiometric hydrogen–methane–oxygen mixtures on hot wires at low pressures

1. Download : Download high-res image (104KB)
2. Download : Download full-size image

     

激光剥蚀电感耦合等离子体质谱法测定纯铝及铝丝中铁、硅、铜、锰、镁、钛、锌、铬和镍

采用激光剥蚀电感耦合等离子体质谱法测定纯铝及铝丝中铁、硅、铜、锰、镁、钛、锌、铬和镍的含量。采用低功率等离子体,以27Al为内标。样品直径为0.5~3 mm时,直径粗细与元素的信号不相关。所有元素的分馏因子在0.94~1.13之间时,可以认为没有分馏效应;纯铝和铝合金的基体效应不明显,铸铝会影响基体效应。测定了块状和丝状标准物质,测定值与认定值基本吻合,纯铝板的测定值与直读光谱法测定结果相一致。受背景干扰的影响,测定值的相对标准偏差(n=5)在2.9%~32%之间。     

Growth of cedar-like Au nanoparticles coating on an etched stainless steel wire and its application for selective solid-phase microextraction

A novel cedar-like Au nanoparticles (AuNPs) coating was fabricated on an etched stainless steel (SS) wire by direct chemical deposition and used as an efficient and unbreakable solid phase microextraction (SPME) fiber. The etched SS wire offers a rough surface structure for subsequent growth of AuNPs in chloroauric acid solution. As a result, the uniform cedar-like AuNPs coating with larger surface area was tightly attached to the etched SS wire substrate. The AuNPs coated etched SS fiber (AuNPs/SS) was examined for SPME of ultraviolet (UV) filters, phthalate esters and aromatic hydrocarbons coupled to high-performance liquid chromatography with UV detection. The fabricated fiber exclusively exhibited excellent extraction efficiency and selectivity for some aromatic hydrocarbons. Influential parameters of extraction and desorption time, temperature, stirring rate and ionic strength were investigated and optimized. The limits of detection ranged from 0.008 μg L⁻¹ to 0.037 μg L⁻¹. The single fiber repeatability varied from 3.90% to 4.50% and the fiber-to-fiber reproducibility ranged from 5.15% to 6.87%. The recovery of aromatic hydrocarbons in real water samples spiked at 2.0 μg L⁻¹ and 20 μg L⁻¹ ranged from 94.38% to 106.2% with the relative standard deviations below 6.44%. Furthermore the growth of the cedar-like AuNPs coating can be performed in a highly reproducible manner. This fabricated fiber exhibits good stability and withstands at least 200 extraction and desorption replicates.     

Simultaneous and Sensitive Detection of Cd(II) and Pb(II) Using a Novel Bismuth Film/Ordered Mesoporous Carbon‐molecular Wire Modified Graphite Carbon Paste Electrode

An electrochemical sensor for the simultaneous and sensitive detection of Cd(II) and Pb(II) is proposed on the basis of square‐wave anodic stripping voltammetry (SWASV) experiments using a novel bismuth film/ordered mesoporous carbon‐molecular wire modified graphite carbon paste electrode (Bi/OMC‐MW/GCPE). Ordered mesoporous carbon (OMC) and molecular wire (MW) (diphenylacetylene) were used as the modifier and binder, respectively. The Bi/OMC‐MW/GCPE was prepared with the addition of graphite powder, OMC and DPA at the ratio of 2 : 1 : 1. The electrochemical properties and morphology of the electrode were characterized by electrochemical impedance spectroscopy (EIS), cyclic voltammetry (CV), SWASV and scanning electron microscopy (SEM). The parameters affecting the stripping current response were investigated and optimized. The experimental results show that the prepared electrode exhibited excellent electrochemical performance, good electrical conductivity and a high stripping voltammetric response. Under optimized conditions, a linear range was achieved over a concentration range from 1.0 to 70.0 μg/L for both Cd(II) and Pb(II) metal ions, with detection limits of 0.07 μg/L for Cd(II) and 0.08 μg/L for Pb(II) (S/N=3) with the deposition time 150 s. Moreover, the sensor exhibited improved sensitivity and reproducibility compared to traditional CPEs. The fabricated electrode was then successfully used to satisfactorily detect Cd(II) and Pb(II) in real soil samples.     

金属丝网——油液介质耦合减振器抗冲击动态力学特性研究

基于金属丝网－油液介质耦合减振器原理样机的抗冲击动态力学特性进行研究，样机的多参数匹配冲击试验研究表明该减振器具有强非线性动态特征，并能实现抗大冲击；在此基础上结合流体理论和库伦摩擦理论建立了原理样机非线性冲击动态特性模型，研究减振器抗冲击力学特性的设计可控性，该建模方法直接引入结构参数，为直接设计具体的器件建立了理论基础。     

Analysis of temperature and stress field in Al alloy’s twin wire welding

By analyzing the shape of twin wire welding’s arcs and the track of droplets’ transition, the phenomenon that the twin wire welding’s fore arc and rear arc all deflect to the middle of the two arcs is found. Based on this the double ellipsoid heat source model is amended, and a heat source model which can apply to calculate the twin wire welding’s temperature field is put forward. This model is testified by actual experiment of temperature sampling. By comparing the temperature field of twin wire welding and single wire welding, the results show that twin wire welding has slender weld pool the end part of which is ellipsoid, and its HAZ is narrower than that of single wire welding. So, twin wire welding can not only reduce the Al alloy generating hot crack, but can also weaken the “overaging” softened phenomenon of heat treated strengthening Al alloy. In the end, the evolving rules of 2219 Al alloy’s longitudinal and transverse stress when welded with twin wire welding are analyzed.     

Effect of Free‐Stream Turbulence on the Flow Structure near a Wedge and the Windward Side of an Airfoil

The flow structure behind wire grids is studied for flows with a low subsonic velocity, and the effect of grids on the boundarylayer flow structure is considered. It is shown that the meanvelocity inhomogeneity induced by the grid does not disappear until a distance of 925 calibers downstream of the grid is reached. Liquidcrystal thermography combined with hotwire measurements made it possible to find the source of steady largescale streamwise vortex structures in the boundary layer on a wedge and on an airfoil and to determine the parameters of these structures.     

电场对金属串配合物M3(dpa)4Cl2 (M=Co,Rh, Ir; dpa=dipyridylamide)结构的影响

应用密度泛函理论PBE0 方法研究具有分子导线潜在应用的金属串配合物M₃(dpa)₄Cl₂ (1: M=Co, 2: M=Rh, 3: M=Ir; dpa=dipyridylamide)在电场作用下的几何和电子结构. 结果表明: 配合物基态均是二重态. 1和2的M₃⁶⁺金属链形成三中心三电子σ键, 3 中M₃⁶⁺形成三中心四电子σ键且存在弱的δ键. 随金属原子周期数增大其M―M键增强、LUMO与HOMO能隙减小、金属原子的反铁磁耦合减弱以至消失且自旋密度向配体的离域增强. 在Cl4→Cl5 电场作用下, 低电势端的M3－Cl5 键缩短, 高电势端的M2―Cl4 键增长, M―M平均键长略为缩短, M―M键增强, 有利于分子线的电子传递; 分子能量降低, 偶极矩线性增大. 低电势端Cl5的负电荷向高电势端Cl4 转移, 且3 中金属原子的正电荷由高电势端向低电势端的转移较明显, 自旋电子由低电势端向高电势端金属原子移动, 但桥联配体dpa^-与M和Cl 所在的分子轴间没有电荷转移. 电场使LUMO与HOMO能隙减小, 有利于分子的电子输运. 随金属原子周期数增大, 电场作用下M―M平均键长变化减小, LUMO、HOMO的能级交错现象减少.     

Spin polarization and temperature dependence of electron effective mass in quantum wires

The electron effective mass in GaAs quantum wires has been estimated by using a full dynamical random-phase approximation to examine its properties versus spin polarization, temperature, and carrier density. A decrease of mass with spin polarization is seen. The minority mass increases with the polarization while the majority mass decreases and this behaviour is seen for all densities. A maximal enhancement of mass at moderate temperature around 25 K is also presented. These calculations show a qualitative consistence with results in two-dimensional systems and help to control the electronic transport in quantum wires.